Board-to-Board Power / Signal Harness for Internal Equipment Interconnects

Product Overview

A board-to-board hybrid harness carries power and low-level signals between two defined PCB interfaces. The connector keying, pin map, conductor sizes, branch points and any shield termination must match the board drawings rather than a generic connector family.

Application Scenarios

• OEM equipment internal wiring and replacement cable programs
• Prototype, pilot-run and repeat production builds based on drawings or samples
• Projects requiring labels, branch control, shielding or protective structures
• Supply-chain replacement projects that need stable engineering documentation

Custom Options

• Connector series, wire gauge, length, branch layout and labels can be customized
• Shielding, overmolding, sleeving, heat shrink and strain relief can be reviewed per drawing
• Samples, photos, BOMs or legacy parts can be used for engineering comparison
• Low-MOQ sampling and repeat production support are available

RFQ Inputs & Material Requirements

Send both board connector BOMs, the end-to-end pin map, voltage and current by circuit, signal types, shield and ground treatment, branch dimensions, routing constraints and electrical acceptance criteria.